Haven't known anyone who had luck with trying to reglue decals. Most just trim the edges off or remove the decals completely. I suppose you could see if they are available from the mfg.
Jim
-- Edited by Jim01 on Wednesday 8th of May 2013 05:24:21 AM
CJSX2fromCT said
11:49 AM May 8, 2013
Haven't noticed a tread for this topic... On our Montana on the p/s the decals near the 5th wheel section are peeling. When we bought it we had them take the decal off the front section it was peeled so bad and they buffed it out. Really looks better without it. On the side though they trimmed the edges back and it looked good, now that it is sitting in the sun the edges are peeling back again and decals are a little brittle. Any thoughts on using something to reglue the edges back down and hold?
The Bear II said
03:21 PM May 8, 2013
Remove them it's not worth the effort of trying to keep up with the peeling edges.
CJSX2fromCT said
10:02 PM May 8, 2013
Ok ty you both... like I said they did remove the one of the nose of theunit and I have to admit it does look good without them
tibbar said
07:13 AM May 10, 2013
We have peeling decals on our RV and what we did was run a plastic scraper over the edges and it took anything curled up right off. The decals looked 100% better. The scraper is about 8 inches wide and came from Home Depot in the muding and taping drywall department.
Haven't known anyone who had luck with trying to reglue decals. Most just trim the edges off or remove the decals completely. I suppose you could see if they are available from the mfg.
Jim
-- Edited by Jim01 on Wednesday 8th of May 2013 05:24:21 AM
Haven't noticed a tread for this topic... On our Montana on the p/s the decals near the 5th wheel section are peeling. When we bought it we had them take the decal off the front section it was peeled so bad and they buffed it out. Really looks better without it. On the side though they trimmed the edges back and it looked good, now that it is sitting in the sun the edges are peeling back again and decals are a little brittle. Any thoughts on using something to reglue the edges back down and hold?