Hi Everyone. Well, after 15 years the RV-Dreams Community Forum is coming to an end. Since it began in August 2005, we've had 58 Million page views, 124,000 posts, and we've spent about $15,000 to keep this valuable resource for RVers free and open. But since we are now off the road and have settled down for the next chapter of our lives, we are taking the Forum down effective June 30, 2021. It has been a tough decision, but it is now time.


We want to thank all of our members for their participation and input over the years, and we want to especially thank those that have acted as Moderators for us during our amazing journey living and traveling in our RV and growing the RV-Dreams Family. We will be forever proud to have been founders of this Forum and to have been supported by such a wonderful community. Thank you all!!

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: Installing solar to replace broken generator and using generator's wiring?


RV-Dreams Community Member

Status: Offline
Posts: 1
Date:
Installing solar to replace broken generator and using generator's wiring?


Hi guys,

I just purchased the first few elements of my solar system (100w panel, wiring and mppt 40amp charge controller), I'm planning to upgrade it gradually to a more powerful system with more panels and batteries.

My generator at the same time is done for, so I wanted to see if I could use the wiring that used to go into the generator to get it into the new charge controller and call it a day so everything would be connected just like before with my generator especially it would avoid for me to set up all the wiring to get to the auxiliary deep cycle battery.

I have different wires that were connected to the generator:

3 wires (one black, one white, one nude which I'm guessing is one hot, one neutral and ground) that go into a transfer switch box. And then separately 2 other wires a little thicker, one with a little metal loop at the end and one with a bolt at its end. I'm not exactly sure where these go, I tried to follow those cords but it ends up being a complex set of connections underneath the RV so I'm not sure.

Let me know your thoughts on this, I hope I'm clear enough explaining the situation but if not I'll be happy to give more details.

Thank you!

Cyrus



__________________


RV-Dreams Family Member

Status: Offline
Posts: 786
Date:

Again, Cyrus, I believe you should run new properly sized solar wiring from the panels to the controller and then from the controller to the batteries. Someday you will replace your generator and you'll be ready to go.

__________________

Winnebago TT 2101DS & 2020 Silverado LTZ Z71. 300 watts WindyNation solar w/MPPT, 2 Trojan T-125s. TALL flag pole. Prefer USFS, COE, BLM, USF&WS, NPS, TVA, state/county camps. 14 year Army vet-11B40 then 11A - old MOS 1542 & 1560.

Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us